forum.netbsd.se - NetBSD Sweden

You are not logged in.

#1 2004-05-17 21:20:25

javajive
Member
From: Dallas, TX
Registered: 2004-05-17
Posts: 1

build.sh -U flag

1.6.1 updated to 1.6.2 - After updating my source files in /usr/src, I built a new kernel and then rebooted. I then rebuilt userland with build.sh. I used the -U flag but many of the permissions got messed up (setuid permissions were gone). Any ideas?

Thanks!

Offline

 

#2 2004-05-17 22:14:01

fredrik
Administrator
From: Göteborg, Sweden
Registered: 2004-05-10
Posts: 229
Website

Re: build.sh -U flag

Is'nt that the purpose of -U?

"-U: set UNPRIVED"

Offline

 

#3 2004-05-18 18:52:40

lars
Member
Registered: 2004-05-15
Posts: 4

Re: build.sh -U flag

Did you use '-U' both when you built and when you later installed? I think the permissions get screwed if installation is done without -U, because the script thinks that root built everything and that it already has the correct permissions..?

Have a faint memory of doing this myself with similar result as you had.

Offline

 

Board footer

Powered by PunBB
© Copyright 2002–2008 PunBB